Updates Your BRX and Accessories

BRX Update

BRX Firmware Updating Instructions

  • Connect BRX to your computer using a USB to Micro USB sync cable
  • Hold down middle BLACK button while powering on the gun, then release the button
  • A new drive letter should appear in file explorer.  
  • Then copy paste firmware to root directory
  • Copy and paste the audio folder to root directory
  • Press middle black (select) button again
  • After 6-8 seconds should installed then gun should start and hear ‘upgrade complete’

( If not, then turn off gun, disconnect USB, and hold select button while power up, then press button a few times, it will boot-up and hear ‘upgrade complete’.)

Headset Update

Headset Firmware Updating Instructions

1. Locate your USB to Micro USB Sync Cable
2. Insert the USB connector into your computer and the Micro­USB connector into the headset port
3. Locate the Boot Mode Button (a recessed button next to the power switch) on your headset
4. Hold the Boot Mode Button down while you power on the headset (you may need to use the end of a
paper­clip or pen to reach the button)
a. Your computer should recognize the device and provide you an AutoPlay window where you
can “Open folder to view files” on your headset
b. You can now release the Boot Mode Button

Adding/Activating the new firmware file to your headset
5. Open the folder for the headset on your computer
6. Delete the existing firmware file(s) in the folder
7. Copy and paste the new firmware file into the folder
8. After the transfer is complete, power off the headset
9. Remove the Micro­USB connector from the headset
10. Congratulations, you have updated your firmware!

Audio Update

Audio Updating Instructions

  • Connect BRX to your computer using a USB to Micro USB sync cable
  • Hold down middle BLACK button while powering on the gun, then release the button
  • A new drive letter should appear in file explorer.
  • Copy and paste the audio folder to root directory